Diagnostic information 2-31
7500-432, -632, and -832
980.03
Service
standard bin
comm.
Exit interface card assembly,
communication failure
A communication error occurred between the printer
engine card assembly and the exit interface card
assembly.
Go to “980.03 Exit interface card assembly
communication failure” on page 2-173.
980.04
Service
duplex comm.
Duplex controller card
assembly communication
failure
A communication error occurred between the printer
engine card assembly and the duplex controller card
assembly.
Go to “980.04 Duplex controller card assembly
communication failure” on page 2-173.
980.05
Service
Flicker comm.
Engine flicker communication
failure
A communication error has occurred in the printer
engine card assembly.
Go to “980.05 Engine flicker communication
failure” on page 2-174.
981.00
Service
finisher error
Stacker bin failure The sensor (stacker bin level) is not turned on within
the specified period after the stacker bin starts
rising.
Refer to the Options Service Manual.
981.01
Service
finisher error
Stacker bin upper limit failure The stacker bin abnormally rises beyond the
specified upper limit position (stacker bin level).
Refer to the Options Service Manual.
981.02
Service
finisher error
Stacker bin lower limit failure The stacker bin abnormally lowers beyond the
specified lower limit position (full stack).
Refer to the Options Service Manual.
982.00
Service
finisher error
Sensor (front tamper HP) on
failure
The sensor (front tamper HP) is not turned on after
the front tamper starts moving to the front tamper
home position.
Refer to the Options Service Manual.
982.01
Service
finisher error
Sensor (front tamper HP) off
failure
The sensor (front tamper HP) is not turned off within
the specified time after the front tamper starts
leaving from the front tamper home position.
Or the sensor (front tamper HP) is turned on again
after the sensor (compiler front tamper HP) is turned
off, and the front tamper stopped its moving.
Refer to the Options Service Manual.
983.00
Service
finisher error
Sensor (rear tamper HP) on
failure
The sensor (rear tamper HP) is not turned on after
the rear tamper starts moving to the rear tamper
home position.
Refer to the Options Service Manual.
983.01
Service
finisher error
Sensor (compiler rear tamper
HP) off failure
The sensor (compiler rear tamper HP) is not turned
off within the specified time after the rear tamper
starts leaving from the rear tamper home position.
Or the sensor (compiler rear tamper HP) is turned
on again after the sensor (compiler rear tamper HP)
is turned off, and the rear tamper stopped its
moving.
Refer to the Options Service Manual.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
