4-150 MFP Service Manual
7500-432, -632, and -832
Large platen glass removal
1. Remove the two screws securing the large platen glass retainer (A) to the scanner unit assembly.
2. Remove the large platen glass retainer (A).
3. Gently lift the large platen glass (B) upward, and move it rightward in the direction of the arrow.
4. Remove the large platen glass (B).
Warning: Do not drop the large platen glass (B), or damage will occur.
CAUTION: Avoid touching the underside of the large platen glass (B).
Note: Before reinstalling the large platen glass (B), clean the underside with glass cleaner, and then install the
large platen glass assembly (B). After installation, clean the top of the large platen glass (B) with glass cleaner.
To Next Page
Loading...
