4-64 MFP Service Manual
7500-432, -632, and -832
MPF pick roll removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the two end screws securing the upper bracket (A) to the MPF feed unit assembly.
4. Remove the upper bracket (A).
5. Release the two hooks securing the two feed shaft cores (B), and slide them both outward.
6. Remove the MPF pick roll (C) from the feed shaft assembly (D) by sliding it to the right in the direction of
the arrow and lifting upward.
Note: When removing the MPF pick roll (C), do not touch the rubber surface.
Note: Before reinstalling the MPF pick roll assembly (C), do not touch the rubber surface.
To Next Page
Loading...
