Lexmark X862de - MPF Feed Shaft Assembly Removal

Repair information 4-63
7500-432, -632, and -832
Go Back
Previous
Next
MPF feed shaft assembly removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the MPF pick roll. See “MPF pick roll removal” on page 4-64.
4. Remove the MPF feed drive gear group. See “MPF feed drive gear group removal” on page 4-59.
5. Remove the two e-rings with a prying tool that secures the feed shaft assembly (A) to the MPF feed unit
assembly.
6. Remove the two bushings (B).
7. Release the hooks securing the two feed shaft cams (C), and slide them inward towards the center of the
MPF feed shaft assembly (A).
8. Remove the feed shaft assembly (A) by moving it to the side then upwards in the direction of the arrow.
Hook
Rear
C
E-Clip
B
C
A
C
B
E-Clip