Lexmark X862de - 2000-Sheet Dual Input (TTM)-Tray 4 Media Guide Rack and Pinion Removal

4-242 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
2000-sheet dual input (TTM)—tray 4 media guide rack and pinion removal
1. Remove the tray 4 assembly. See “2000-sheet dual input (TTM)—tray 4 assembly removal” on
page 4-223.
2. Place the tray 4 assembly on its right side, as shown in the figure.
3. Remove two e-clips securing the two pinion gears (A) to the frame assembly (B).
4. Remove two pinion gears (A).
5. Remove four screws securing the two rack gears (C) to the frame assembly (B).
C
E-ring
A
A
C
B
E-ring