Repair information 4-5
7500-432, -632, and -832
Top cover assembly removal
Note: First remove the bridge unit and finisher, if equipped.
1. Remove the operator panel assembly. See “Operator panel assembly removal” on page 4-135.
2. Remove the printer front door assembly. See “Printer front door assembly removal” on page 4-6.
3. Remove the printer front left cover. See “Printer front left cover removal” on page 4-3.
4. Remove two screws securing the top cover assembly (A).
5. Remove the top cover assembly (A) by sliding it to the right and then forward in the direction of the arrow.
To Next Page
Loading...
