Lexmark X862de - Sensor (Exit 2) Static Jam

2-46 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
203.03 Sensor (exit 2) static jam
9 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Go to “Printer
engine card
assembly removal”
on page 4-119.
Problem solved.
Step Check Yes No
1 Check the media position.
Open the exit 2 left door assembly, and visually check it.
Does the media touch the sensor (exit 2)?
Remove the media. Go to step 2.
2 Check the sensor (exit 2) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Exit2.
Open the printer left door assembly and the exit 2 left
door assembly.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
Go to step 4. Go to step 3.
3 Check the sensor (exit 2) for proper connection.
Is the above sensor connected properly?
Replace the sensor
(exit 2).
Go to “Exit 2
sensor (exit 2)
removal” on
page 4-335.
Replace the
connection.
4 Perform a print test.
Does the error still occur?
Replace the exit
interface card
assembly.
Go to “Exit
interface card
assembly removal”
on page 4-117.
Go to step 5.
Problem solved.
5 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Go to “Printer
engine card
assembly removal”
on page 4-119.
Problem solved.
Step Check Yes No