Lexmark X862de - Pick Roll Position Motor Assembly Removal

4-190 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Pick roll position motor assembly removal
1. Open the ADF left cover assembly.
2. Remove the ADF left cover media guide. See “ADF left cover media guide removal” on page 4-189.
3. Remove the document set actuator. See “” on page 4-187.
4. Remove the screw from the green ground wire (A).
5. Remove the screw securing the grounding plate (B).
6. Remove the grounding plate (B).
7. Remove the two screws securing the harness guide (C).
8. Remove the harness guide (C).
9. Disconnect the connector from the pick roll position motor assembly (D).
10. Remove the one screw securing the pick roll position motor assembly (D).
11. Remove the pick roll position motor assembly (D).
12. Remove the harness from the harness guide (C).
B
A
C
D
Connector