Lexmark X862de - ADF Transport Roll Assembly Removal

4-206 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
ADF transport roll assembly removal
1. Open the ADF left cover assembly.
2. Remove the ADF front cover assembly. See “ADF front cover assembly removal” on page 4-174.
3. Remove the ADF rear cover. See “ADF rear cover removal” on page 4-173.
4. Remove the ADF feed drive motor assembly. See “ADF feed drive motor assembly removal” on
page 4-180.
5. Remove the actuator/media guide assembly. See “Actuator/media guide assembly removal” on
page 4-198.
6. Remove the e-clip securing the manual feed drive wheel (A).
7. Remove the manual feed drive wheel (A).
8. Remove the manual feed drive belt (B).
9. Remove the e-clip securing the bushing 8 mm (C).
10. Remove the bushing 8 mm (C).
11. Remove the e-clip securing the transport roll drive gear 20T (D).
12. Remove the transport roll drive gear 20T (D).
13. Remove the bushing 8 mm (E).
14. Move the ADF transport roll assembly (F) rearward and upward.
15. Remove the ADF transport roll assembly (F).
Warning: Do not touch the rubber surface of the ADF transport roll assembly (F).
F
E
D
E-clip
AB
C
E-clip
Front