4-322 MFP Service Manual
7500-432, -632, and -832
Exit 2 removals
Exit 2 unit assembly removal
1. Open the printer left door assembly (A).
2. Lift the two levers (B) while pulling the exit 2 unit (C) outward in the direction of the arrow.
3. Remove the exit 2 unit (C).
Note: The rear side of the exit 2 unit (C) may require some force to disengage the electrical connector.
Note: Before reinstalling, ensure the exit 2 (C) unit is properly aligned and the electrical connector is
properly connected.
To Next Page
Loading...
