Lexmark X862de - Sensor (MPF Media Out) Removal

4-56 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Sensor (MPF media out) removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the two hooks securing the upper frame (A) to the MPF feed unit assembly.
4. Remove the upper frame (A) by moving it up and out in the direction of the arrow.
5. Disconnect the connector from the sensor (MPF media out) (B).
6. Release the hooks securing the sensor (MPF media out) (B) in the upper frame (A).
7. Remove the sensor (MPF media out) (B).
Hook
A
Connector
Hook
(Upper frame)
Right
Slot
B