Lexmark X862de - Sensor (Exit 2 Media Shift HP) Failure

Diagnostic information 2-157
7500-432, -632, and -832
Go Back
Previous
Next
919.00 Sensor (exit 2 media shift HP) failure
Step Check Yes No
1 Check the sensor (exit 2 media shift HP) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Exit2 shift HP.
Move the shift assembly with your finger in a side to
side motion.
Does the display on the operator panel change every
time the sensing area of the above sensor is blocked?
Go to step 3. Go to step 2.
2 Check the sensor (exit 2 media shift HP) for proper
connection.
Is the above sensor connected properly?
Replace the sensor
(exit 2 media shift
HP).
Go to “Exit 2
sensor (exit 2
media shift HP)
removal” on
page 4-336.
Replace the
connection.
3 Check the media shift motor for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor Test.
4. Touch Exit2 shift mtr.
Does the above motor rotate properly?
Go to step 5. Go to step 4.
4 Check the media shift motor for proper connection.
Is the above motor connected properly?
Replace the media
shift motor.
Go to “Exit 2 unit
assembly removal”
on page 4-322.
Replace the
connection.
5 Perform a print test.
Does the error still occur?
Replace the exit
interface card
assembly.
Go to “Exit
interface card
assembly removal”
on page 4-117.
Go to step 6.
Problem solved.
6 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Go to “Printer
engine card
assembly removal”
on page 4-119.
Problem solved.