Lexmark X862de - Size Mismatch Jam (no MIX-Size)

Diagnostic information 2-119
7500-432, -632, and -832
Go Back
Previous
Next
295.01 Size mismatch jam (no mix-size)
7 Check the sensor (ADF width APS 3) for connection.
Is the above sensor connected properly?
Replace the
sensor (ADF
width APS 3).
Go to “Sensor
(ADF width APS
3)” on
page 4-194.
Replace the
connection.
8 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the ADF
controller card
assembly.
Go to “ADF
controller card
assembly
removal” on
page 4-175.
Go to step 9.
9 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-130.
Problem solved.
Step Check Yes No
1 Check the document size.
Is the correct size document being inserted into the ADF?
Go to step 2. Insert the proper
size document into
the ADF.
2 Check the document tray media guide position.
Are the document tray media guides set correctly?
Go to step 3. Adjust the
document tray
media guides to
the proper
position.
3 Check the connection of each ADF controller card assembly
connector.
Is each connector of ADF controller card assembly connected
properly?
Go to step 4. Connect each
connector of ADF
controller card
assembly properly.
4 Perform a POR.
Does the error remain when the power is turned off/on?
Replace the
ADF controller
card assembly.
Go to “ADF
controller card
assembly
removal” on
page 4-175.
Problem solved.
5 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the
RIP card
assembly.
Go to “RIP card
assembly
removal” on
page 4-130.
Problem solved.
Step Check Yes No