Lexmark X862de - Sensor (Exit 1 Media Shift) Removal

Repair information 4-109
7500-432, -632, and -832
Go Back
Previous
Next
Sensor (exit 1 media shift) removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-15.
4. Open the printer left door assembly.
5. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-322.
6. Open the printer front door assembly.
7. Remove the printer front left cover. See “Printer front left cover removal” on page 4-3.
8. Remove the exit 1 media shift assembly. See “Exit 1 media shift assembly removal” on page 4-105.
9. Remove the media shift motor. See “Media shift motor removal” on page 4-108.
10. Remove the two screws securing the bracket (A) to the exit 1 media shift assembly (B).
11. Remove the bracket (A).
12. Release the hooks securing the sensor (exit 1 media shift) (C) to the bracket (A).
13. Remove the sensor (exit 1media shift) (C).
B
C
A
Hooks
Left
Hook