Lexmark X862de - 2000-Sheet Dual Input (TTM)-Media Guide Rack and Pinion Removal

4-230 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
7. Remove two E-clips with a prying tool securing the two small pulleys (D) on the front of the frame
assembly.
8. Remove two small guides (E) and the two small pulleys (D).
9. Remove the tray 3 front cables (C) from the bottom plate (F).
Note: Before re-installing:
– It is recommended that all four cables be replaced.
– Ensure tray 3 front cables (C) are not twisted or kinked.
– Route the cables properly as shown in the figure.
– Replace the cables by setting the frame assembly (B) on its side as shown in the figure.
2000-sheet dual input (TTM)—media guide rack and pinion removal
1. Remove the tray 3 assembly. See “2000-sheet dual input (TTM)—tray 3 assembly removal” on
page 4-224.
2. Place the tray 3 assembly on its right side.
3. Remove two e-clips securing the two pinion gears (A) to the frame assembly (B).
4. Remove the two pinion gears (A).
5. Remove the four screws securing the two rack gears (C) to the frame assembly (B).