Repair information 4-237
7500-432, -632, and -832
2000-sheet dual input (TTM)—tray 4 rear cables removal
1. Remove the tray 4 assembly. See “2000-sheet dual input (TTM)—tray 4 assembly removal” on
page 4-223.
2. Remove the tray 4 front cover. See “2000-sheet dual input (TTM)—tray 4 front cover removal” on
page 4-235.
3. Place the tray 4 assembly on its right side as shown in the figure.
4. Remove the E-clip with a prying tool securing the tray lift cable pulley (A) to the tray lift shaft assembly (B).
5. Gently move the tray lift shaft assembly (B) toward the rear of the tray and detach the rear bushing (C)
from the frame.
Note: Do not remove the front lift cable pulley (A) or the front lift cables will become detached.
6. Move the rear portion of the tray lift shaft assembly (B) away from the frame.
7. Move the rear the rear lift cable pulley (E) toward the rear of the tray to release the two tray 4 rear cables
(D) from the tray lift shaft assembly (B).
8. Remove the two tray 4 rear cables (D) from the tray lift shaft assembly (B).
To Next Page
Loading...
