Lexmark X862de - Scanner Tests; Asic Test; Feed Test

Diagnostic aids 3-25
7500-432, -632, and -832
Go Back
Previous
Next
SCANNER TESTS
ASIC Test
This operation performs a diagnostic test on the scanner ASIC that cycles through all of the scanner ASIC's
memory.
To perform the ASIC Test:
1. Touch SCANNER TESTS from the Diagnostics Menu.
2. Touch ASIC Test.
During this test, ASIC Test Running... appears on the display. At the completion of this test, ASIC Test Passed
or ASIC Test Failed appears on the display. To clear the message, press Stop .
Feed Test
This test continuously executes flatbed and/or ADF scans but does not produce any printed output.
To perform the Feed Test:
1. Touch SCANNER TESTS from the Diagnostics Menu.
2. Touch Feed Test.
You are prompted to select a paper size for the ADF. For flatbed scans, the full length of the flatbed is traversed.
The device decides whether to run the flatbed or the ADF according to the following flowchart:
During the test, Running... Flatbed:xxxxx ADF:xxxxx appears on the display. The Flatbed number increases
each time the scanner performs a flatbed scan, and the ADF number increases each time the scanner performs
an ADF scan.
Press Stop to end this test.
If an error occurs (such as a scanner jam), Feed Test Failed Flatbed:xxxxx ADF:xxxxx appears on the display.
To clear the message, press Stop .
Paper
in
ADF?
Scan the full
length of the
flatbed.
Scan all pages
from the ADF,
assuring selected
paper size.
No
Yes