Lexmark X862de - Duplex Media Transport Rolls Removal

4-320 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Duplex media transport rolls removal
1. Remove the duplex unit assembly. See “Duplex unit assembly removal” on page 4-284.
2. Remove the duplex assembly. See “Duplex controller card assembly removal” on page 4-311.
3. Remove the duplex drive gears 28T. See “Duplex drive gear 28 tooth removal” on page 4-290.
4. Remove the hooks of the four bushings (A) securing the two duplex media transport rolls (B) to the duplex
unit assembly.
5. Remove the two duplex media transport rolls (B).
Note: When removing the two duplex media transport rolls (B), do not touch the rubber surface.
Note: When replacing the two duplex media transport rolls (B), do not touch the rubber surface.
B
Hook
A
A
Hook
Hook
B
A
Hook
A
Right