Lexmark X862de - Hard Drive Removal

4-128 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Hard drive removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the RIP card chassis bracket. See “RIP card chassis bracket removal” on page 4-127.
Warning: Do not drop the RIP card chassis bracket, or damage will occur.
3. Remove the connector from the hard drive (A).
4. Remove the two screws securing the hard drive (A) to the RIP card chassis bracket (B).
5. Pull the hard drive (A) to release the three locator snaps.
6. Remove the hard drive (A).
Warning: Do not drop the hard drive, or damage will occur.
connector
B
A