Lexmark X862de - Exit Interface Card Assembly Removal

Repair information 4-117
7500-432, -632, and -832
Go Back
Previous
Next
Exit interface card assembly removal
1. Remove the top cover assembly. See “Top cover assembly removal” on page 4-5.
2. Disconnect all the connectors from the exit interface card assembly (A).
Note: Connector P430 has a hook that must first be released.
3. Remove the two screws securing the exit interface card assembly (A).
4. Release the plastic supports securing the exit interface card assembly (A).
5. Remove the exit interface card assembly (A) along with the bracket (B).
6. Remove the two screws securing the exit interface card assembly (A) to the bracket (B).
Connector
Plastic support
Connector
A
B
Front