Lexmark X862de - 2000-Sheet Dual Input (TTM)-2 TM;TTM Media Transport Roll Assembly Removal

Repair information 4-253
7500-432, -632, and -832
Go Back
Previous
Next
2000-sheet dual input (TTM)—2TM/TTM media transport roll assembly removal
1. Open the left door assembly.
2. Remove two screws securing the bracket (A).
3. Disconnect the connector to the sensor (tray 3 feed-out) (B).
4. Remove the bracket (A).
5. Remove the large e-clip on the left securing the 2TM/TTM media transport roll assembly (C).
6. Slide the bushing (D) to the right.
7. Move the 2TM/TTM media transport roll assembly (C) leftward and outward in the direction of the arrow to
remove.
8. Remove the 2TM/TTM media transport roll assembly (C).
Note: One of the bushings may become detached.
Note: When removing the 2TM/TTM media transport roll assembly (C), do not touch the rubber surface.
Note: Before re-installing the 2TM/TTM media transport roll assembly (C), do not touch the rubber surface.
D
Projection
Notch
E-ring
Connector
B
A
C
E-ring
D