Lexmark X862de - Operator Panel Assembly Removal

Repair information 4-135
7500-432, -632, and -832
Go Back
Previous
Next
Operator panel assembly removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Disconnect the four connectors from the RIP card assembly (A).
3. Pull the stud (B) securing the filter (C) away from the rear motor cover (D).
4. Remove the filter (C).
5. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
6. Remove the controller box side cover. See “Controller box side cover removal” on page 4-18.
7. Remove the rear upper cover. See “Rear upper cover removal” on page 4-15.
connectors
A
Rear
B
C
D