Lexmark X862de - MPF Pick Solenoid; Pick Lever Removal

4-62 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
MPF pick solenoid / pick lever removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the MPF feed drive gear group. See “MPF feed drive gear group removal” on page 4-59.
4. Remove one screw securing the pick solenoid (A).
5. Disconnect the connector from the pick solenoid (A).
6. Remove the MPF pick solenoid (A).
Note: When removing the pick solenoid (A), lower the actuator (B).
7. Remove the pick lever (B).
8. Remove the spring (C).
C
B
A
Rear
Actuator