Repair information 4-37
7500-432, -632, and -832
Media feed unit drive gear - 13 tooth removal
1. Remove the appropriate media feed unit assembly. See “Media feed unit assembly 1 removal” on
page 4-20, or “Media feed unit assembly 2 removal” on page 4-23.
2. Remove the harness from the bracket (A).
3. Remove the three screws securing the bracket (A) to the media feed unit assembly.
4. Remove the bracket (A).
Note: Gears may become detached from the bracket (A).
5. Remove the tray lift one-way clutch. See “Tray lift one way clutch/gear assembly removal” on
page 4-35.
6. Remove the tray lift one-way gear 24 tooth. See “Tray lift one way clutch/gear assembly removal” on
page 4-35.
7. Remove the media feed unit drive gear - 13 tooth (B).
Note: Before reinstalling, ensure all gears and washers are securely attached to the bracket (A).
To Next Page
Loading...
