Lexmark X862de - MPF Pressure Pad Removal

4-60 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
MPF pressure pad removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the MPF pick roll. See “MPF pick roll removal” on page 4-64.
4. Remove the MPF feed shaft assembly. See “MPF feed shaft assembly removal” on page 4-63.
5. Remove the two springs (A) under the pressure pad (B).
6. Turn the MPF upside down, and pry the shaft out with a flat blade screwdriver.
7. Remove the separation pad (B) and the shaft (C) by moving it in the direction of the arrow from the
backside.
Note: Before reinstalling, ensure the two springs (A) remain in the proper position during reassembly of
the feed shaft assembly and MPF feed roll.
A
B
C
C
Front
Botton
Rear
A