Lexmark X862de - Sensor (Registration) on Jam (Tray 3 Media Feed)

Diagnostic information 2-67
7500-432, -632, and -832
Go Back
Previous
Next
243.03 Sensor (registration) on jam (tray 3 media feed)
7 Check the sensor (tray 2 feed-out) for proper
connection.
Is the above sensor connected properly?
Replace the sensor
(tray 2 feed-out).
Go to “Sensor
(tray 2 feed-out)
removal” on
page 4-83.
Replace the
connection.
8 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor Test.
4. Touch Tray 3.
5. Touch Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
Go to step 10. Go to step 9.
9 Check the sensor (tray 3 feed-out) for proper
connection.
Is the above sensor connected properly?
Replace the sensor
(tray 3 feed-out).
Go to “2000-sheet
dual input (TTM)—
sensor (tray 3 feed-
out) removal” on
page 4-254.
Replace the
connection.
10 Check the 2TM/TTM controller card assembly and the
printer engine card assembly for proper connection.
Are connectors P541 and P413 on the above cards
connected properly?
Go to step 11. Replace the
connection.
11 Perform a print test.
Does the error still occur?
Replace the 2TM/
TTM controller card
assembly.
Go to “2000-sheet
dual input (TTM)—
2TM/TTM controller
card assembly
removal” on
page 4-281.
Go to step 11.
Problem solved.
12 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Go to “Printer
engine card
assembly removal”
on page 4-119.
Problem solved.
Step Check Yes No
1 Check the media condition.
Is the media in the tray crumpled or damaged?
Replace the media. Go to step 2.
Step Check Yes No