Lexmark X862de - 2000-Sheet Dual Input (TTM)-Media Feed Unit Drive Gear 13 Tooth Removal

Repair information 4-259
7500-432, -632, and -832
Go Back
Previous
Next
2000-sheet dual input (TTM)—media feed unit drive gear 13 tooth removal
1. Remove the media feed unit assembly. See “2000-sheet dual input (TTM)—media feed unit assembly
removal (tray 3)” on page 4-250 or “2000-sheet dual input (TTM)—media feed unit assembly
removal (tray 4)” on page 4-246.
2. Remove the harness from the bracket (A).
3. Remove the three screws securing the bracket (A) to the media feed unit assembly.
4. Remove the bracket (A).
Note: Gears may become detached from the bracket (A).
5. Remove the tray lift one-way clutch. See “2000-sheet dual input (TTM)—feed roll one-way clutch
removal” on page 4-267.
6. Remove the tray lift one-way gear 24 tooth. See “2000-sheet dual input (TTM)—one-way 22 tooth
removal” on page 4-268.
7. Remove the media feed unit drive gear - 13 tooth (B).
Note: Before re-installing, ensure all gears and washers are securely attached to the bracket (A).
Harness
Clamp
A
Rear
Washer
Washer
B