2-186 MFP Service Manual
7500-432, -632, and -832
Standard bin 2 full
2 Check the sensor (standard bin full exit 1) for operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Exit level.
4. Touch Standard bin full 1.
Does the display on the operator panel change every time
the sensing area is blocked?
Go to step 5. Go to step 3.
3 Check the sensor (standard bin full 1) connection.
Is the sensor (standard bin full 1) properly connected?
Replace the
sensor (standard
bin full exit 1).
Go to “Sensor
(exit 1 bin full)
removal” on
page 4-110.
Replace the
connection.
Go to step 4.
4 Check the exit interface card assembly connection P432,
P433, and P434.
Is the exit interface card assembly properly connected
P432, P433, and P434?
Replace the exit
interface card
assembly.
Go to “Exit
interface card
assembly
removal” on
page 4-117.
Replace the
connection.
5 Perform a print test.
Does the error continue?
Replace the
printer engine card
assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-119.
Problem solved.
Step Check Yes No
1 Check the actuator for movement.
Does the media weight assembly move up and down
normally?
Go to step 2. Reinstall the
media weight
assembly.
2 Check the sensor (standard bin full exit 2) for operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Exit level.
4. Touch Standard bin full 2
Does the display on the operator panel change every time
the sensing area is blocked?
Go to step 5. Go to step 3.
Step Check Yes No
To Next Page
Loading...
