Lexmark X862de - Exit 2 Actuator Removal

4-330 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Exit 2 actuator removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-322.
2. Open the exit 2 unit assembly.
3. Remove the exit 2 left cover. See “Exit 2 left cover removal” on page 4-325.
4. Remove the exit 2 right cover. See “Exit 2 right cover removal” on page 4-327.
5. Release the spring (A) on the exit 2 actuator (B).
6. Move the exit 2 actuator (B) to the right in the direction of the arrow to release two hooks.
7. Remove the exit 2 actuator (B).
8. Remove the spring (A) from the exit 2 actuator (B).
Note: Before reinstalling the exit 2 actuator (B), ensure the spring (A) is properly installed.
B
B
A
A
Front