4-126 MFP Service Manual
7500-432, -632, and -832
Finisher AC output removal
1. Remove the RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Remove the rear lower cover. See “Rear lower cover removal” on page 4-12.
4. Remove the printer engine card assembly. See “Printer engine card assembly removal” on
page 4-119.
5. Remove the three screws securing the bracket (A).
6. Disconnect the three connectors to the finisher AC output (B).
7. Release the two hooks securing the finisher AC output (B) to the bracket (A).
8. Remove the finisher AC output (B).
Warning: Before reinstalling, ensure all connectors are plugged into their proper location to prevent
damage.
To Next Page
Loading...
