Lexmark X862de - ADF Feed Drive Motor Assembly Removal

4-180 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
ADF feed drive motor assembly removal
1. Open the ADF left cover assembly.
2. Lift the document tray assembly.
3. Remove the ADF rear cover. See “ADF rear cover removal” on page 4-173.
4. Remove the ADF registration motor. See “ADF registration motor removal” on page 4-209.
5. Disconnect the three connectors from the ADF dual drive motor assembly (A).
6. Remove the screw securing the harness guide (B) to the ADF.
7. Remove the two screws securing the ADF dual drive motor assembly (A) to the base of the ADF.
8. Remove the two screws securing the ADF dual drive motor assembly (A) to the rear of the ADF.
9. Remove the stud screw securing the ADF dual drive motor assembly (A) to the rear of the ADF.
10. Remove the plastic support (C).
11. Remove the connectors P751, P754, P755, P758, P761, P785 and P786 from the ADF controller card
assembly (D).
12. Remove the harness guide (B) containing the harnesses and swing it out of the way.
13. Remove the ADF dual drive motor assembly (A) from the ADF.
P760
P759
P758
P785
P761
P751
P752
P753
P754
P755
P786
P756
P757
A
D
A
C
B
Connectors
Stud screw