Repair information 4-61
7500-432, -632, and -832
MPF transport roll assembly removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the two end screws securing the upper bracket to the MPF feed unit assembly.
4. Remove the upper bracket.
5. Remove the MPF transport gear - 18 tooth (A).
Note: The MPF transport gear - 18 tooth will be tight and requires extra force to remove.
6. Remove the transport shaft collar (B).
7. Remove the e-clip with a prying tool securing the MPF transport roll assembly (C) to the MPF feed unit
assembly.
8. Remove the two bushings 8 mm (D).
9. Remove the MPF transport roll assembly by moving it rightward then upward in the direction of the arrow.
Note: When removing the MPF transport roll assembly (C), do not touch the rubber surface.
Note: Before reinstalling the MPF transport roll assembly (C), do not touch the rubber surface.
To Next Page
Loading...
