Lexmark X862de - Sensor (ADF Registration) on Jam ADF Simplex Side 1

Diagnostic information 2-91
7500-432, -632, and -832
Go Back
Previous
Next
290.11 Sensor (ADF registration) on jam ADF simplex side 1
4 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the
ADF controller
card assembly.
Go to “ADF
controller card
assembly
removal” on
page 4-175.
Go to step 5.
5 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-130.
Problem solved.
Step Check Yes No
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes, or excessive
wear?
Go to step 2. Remove damaged
original document,
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to step
2.
2 Check the ADF rolls for wear.
Is the ADF feed/pick roll assembly or the ADF separation roll
guide assembly free of excess wear?
Go to step 3. Clean or replace
the ADF feed/pick
roll assembly or
the ADF
separation roll
guide assembly.
Go to “ADF feed/
pick roll
assembly
removal” on
page 4-186 or
“ADF separation
roll guide
assembly” on
page 4-203.
3 Check the media path for contaminates.
Is the media path free of excess media dust and foreign
objects such as paper clips and staples?
Go to step 4. Remove all
contaminates from
the media path.
Step Check Yes No