4-108 MFP Service Manual
7500-432, -632, and -832
Media shift motor removal
1. Remove the rear RIP card cover. See “Rear RIP card cover removal” on page 4-13.
2. Remove the rear motor cover. See “Rear motor cover removal” on page 4-11.
3. Remove the rear upper cover. See “Rear upper cover removal” on page 4-15.
4. Open the printer left door assembly.
5. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-322.
6. Open the printer front door assembly.
7. Remove the printer front left cover. See “Printer front left cover removal” on page 4-3.
8. Remove the exit 1 media shift assembly. See “Exit 1 media shift assembly removal” on page 4-105.
9. Disconnect the connector from the media shift motor (A).
10. Remove the two screws securing the media shift motor (A) to the exit 1 media shift assembly (B).
11. Remove the media shift motor (A).
Warning: Before reinstalling, secure the media shift motor (A) harness to the clamps on the exit 1 media shift
assembly (B) to prevent damage.
To Next Page
Loading...
