Lexmark X862de - Sensor (Registration) Static on Jam

Diagnostic information 2-37
7500-432, -632, and -832
Go Back
Previous
Next
200.01 Sensor (registration) static on jam
Step Check Yes No
1 Check the media position.
Open the printer left door assembly, and visually check it.
Does the media touch the sensor (registration)?
Remove the
media.
Go to step 2.
2 Check the sensor (registration) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Registration.
Open the printer left door assembly, and check it.
Does the display on the operator panel change every time
the sensor actuator is operated?
Go to step 4. Go to step 3.
3 Check the sensor (registration) connection.
Is the sensor (registration) properly connected?
Replace the
sensor
(registration).
Go to “Sensor
(registration)
removal” on
page 4-81.
Replace the
connection.
4 Perform a print test.
Does the error continue?
Replace the
printer engine card
assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-119.
Problem solved.