Lexmark X862de - Registration Clutch Assembly Removal

4-80 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Registration clutch assembly removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the printer left door assembly. See “Printer left door assembly removal” on page 4-75.
4. Remove the registration roll assembly. See “Registration roll assembly removal” on page 4-79.
5. Remove the e-ring with a prying tool securing the registration clutch assembly (A) to the registration roll
assembly (B).
6. Remove the registration clutch assembly (A) along with the harness.
Note:
• Before reinstalling, the harness for the clutch must be placed through the hole on the registration roll
assembly (B).
• Before reinstalling, the notch on the registration clutch assembly (A) must be placed over the boss of
the registration roll assembly (B).
A
E-ring
Boss
Notch
B