Lexmark X862de - Exit 2 Sensor (Exit 2 Media Shift HP) Removal

4-336 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Exit 2 sensor (exit 2 media shift HP) removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-322.
2. Open the exit 2 unit assembly.
3. Remove the exit 2 left cover. See “Exit 2 left cover removal” on page 4-325.
4. Remove the exit 2 right cover. See “Exit 2 right cover removal” on page 4-327.
5. Remove the exit 2 media shift gear. See “Exit 2 media shift gear removal” on page 4-333.
6. Rotate the shift assembly (A) upward in the direction of the arrow.
7. Disconnect the connector from the sensor (exit 2 media shift HP) (B).
8. Release the hooks securing the sensor (exit 2 media shift HP) (B) to the exit 2 unit assembly.
9. Remove the sensor (exit 2 media shift HP) (B).
LOW CHUTE
B
A
Connector
Hooks
Rear