Diagnostic aids 3-5
7500-432, -632, and -832
MOTOR TESTS
The tests in this group allow you to test specific motors, and on some motors run them forward or reverse.
To run the MOTOR TESTS:
1. Touch MOTOR TESTS from the Diagnostics Menu.
2. Touch the test to run.
3. During the test, Motor Running... appears on the display.
Note: If available, Forward and Reverse options appear on the display for selected tests.
Press Stop to stop the test.
The following Finisher Motor Tests are available:
• Sub paddle solenoid • Punch unit mtr
• Media eject clutch • Fin diverter solenoid
• Stapler unit mtr • Fin Buffer solenoid
• Bridge unit drv mtr • Punch carriage shift mtr
• Motor (entrance/paddle) • Front tamper mtr
• Motor (buffer/transport) • Rear tamper mtr
• Motor (exit) • Stapler carriage mtr
• Media eject clamp mtr • Stacker lift mtr
• Media eject mtr
The following Printer Motor Tests are available:
• Transport mtr • Tray 4 feed mtr
• 2TM/TTM drv mtr • Tray 5 feed mtr
• 2TM/TTM Clutch • MPF pick solenoid
• HCF transport mtr • Duplex drv mtr
• HCF pick solenoid • Diverter solenoid
• MPF/Transport mtr • Exit 2 cooling fan
• Fuser cooling fan • Tray 1 lift mtr
• PC unit cooling fan • Tray 2 lift mtr
• Toner add mtr • Tray 3 lift mtr
•Drum unit •Tray 4 lift mtr
• Registrat clutch • Tray 5 lift mtr
• Tray 1 feed mtr • Exit 1 shift mtr
• Tray 2 feed mtr • Exit 2 shift mtr
• Tray 3 feed mtr • Exit 2 drive mtr
The following Scanner Motor Tests are available:
• ADF feed drv mtr • Scanner drv mtr
• Exposure lamp • Inverter solenoid
• Scanner cooling fan • Pick roll position mtr
• ADF registration drv mtr • Document set LED
To Next Page
