Lexmark X862de - Sensor (Tray 3 Feed-Out) on Jam (Tray 3 Media Feed)

2-64 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
243.01 Sensor (tray 3 feed-out) on jam (tray 3 media feed)
11 Perform a print test.
Does the error still occur?
Replace the 2TM/
TTM controller card
assembly.
Go to “2000-sheet
dual input (TTM)—
2TM/TTM controller
card assembly
removal” on
page 4-281.
Go to step 12.
Problem solved.
12 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Go to “Printer
engine card
assembly removal”
on page 4-119.
Problem solved.
Step Check Yes No
1 Check the media condition.
Is the media in the tray crumpled or damaged?
Replace the media. Go to step 2.
2 Check the media size setup.
Does the media size in use match the size set for tray
3?
Go to step 3. Replace the media,
or change the media
size setup.
3 Check the tray 3 rolls.
Pull out the tray 3, and check it.
Are the feed roll, separation roll, and pick roll for
transport free of excess wear and contamination?
Go to step 4. Clean or replace the
feed roll, separation
roll, and pick roll.
Go to “2000-sheet
dual input (TTM)—
feed roll removal”
on page 4-266,
“2000-sheet dual
input (TTM)—
separation roll
removal” on
page 4-270, and
“2000-sheet dual
input (TTM)—pick
roll removal” on
page 4-273.
4 Check the media position.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the media touch the tray 3 feed-out sensor or the
sensor (pre-feed) of the tray 3 media feed unit
assembly?
Remove the media. Go to step 5.
Step Check Yes No