Lexmark X862de - Media Feed Unit Drive Gear - 28; 21 Tooth Removal

4-42 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Media feed unit drive gear - 28 / 21 tooth removal
1. Remove the appropriate media feed unit assembly. See “Media feed unit assembly 1 removal” on
page 4-20, or “Media feed unit assembly 2 removal” on page 4-23.
2. Remove the harness from the bracket (A).
3. Remove the three screws securing the bracket (A) to the media feed unit assembly.
4. Remove the bracket (A).
Note: The gears may become detached from the bracket (A).
5. Remove the media feed unit drive gear - 28 / 21 tooth (B).
Note: Before reinstalling, ensure all gears and washers are securely attached to the bracket (A).
Washer
Clamp
Rear
A
Rear
Harness
B