4-240 MFP Service Manual
7500-432, -632, and -832
2000-sheet dual input (TTM)—tray 4 front cables removal
1. Remove the tray 4 assembly. See “2000-sheet dual input (TTM)—tray 4 assembly removal” on
page 4-223.
2. Remove the tray 4 front cover. See “2000-sheet dual input (TTM)—tray 4 front cover removal” on
page 4-235.
3. Place the tray 4 assembly on its right side, as shown in the figure.
4. Remove the E-clip with a prying tool securing the front tray lift pulley (A) to the tray lift shaft assembly (B).
5. Remove the front tray lift pulley (A).
Note: The tray 4 front cables (C) become detached.
6. Remove the tray 4 front cables (C) from the tray lift shaft assembly (B).
To Next Page
Loading...
