Lexmark X862de - Media Size Mismatch in Width

2-178 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
Media size mismatch in width
4 Check the switch (media size) connection for tray 1 and/or
tray 2.
Is the switch (media size) properly connected for tray 1 and/or
tray 2?
Replace the
required switch
(media size).
Go to “Toner
cartridge guide
assembly
removal” on
page 4-95.
Replace the
connection.
5 Perform a print test.
Does the error continue?
Replace the
printer engine
card assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-119.
Problem solved.
Step Check Yes No
1 Check the media.
Pull out the tray, and visually check it.
Is the media loaded in tray properly?
Go to step 2. Load media
properly.
2 Check the media.
Pull out the tray, and visually check it.
Are the front media guide and rear media guide on
tray 3 or tray 4 set correctly?
Go to step 3. Set the parts
correctly.
3 Check the switch (TTM media size) for proper
installation.
Pull out the tray, and visually check it.
Is the switch (TTM media size) for tray 3 or tray 4
installed properly?
Go to step 4. Install the switch
(TTM media size)
correctly.
Go to “2000-sheet
dual input (TTM)—
switch (TTM media
size) removal” on
page 4-249.
4 Check the switch (TTM media size) for proper
connection.
Check tray 3 and tray 4.
Are the above sensors connected properly?
Replace the
appropriate switch
(TTM media size).
Go to “2000-sheet
dual input (TTM)—
switch (TTM media
size) removal” on
page 4-249.
Replace the
connection.
5 Check the 2TM/TTM controller card assembly and the
printer engine card assembly for proper connection.
Are connectors P541 and P413 on the above cards
connected properly?
Go to step 6. Replace the
connection.
Step Check Yes No