Repair information 4-81
7500-432, -632, and -832
Sensor (registration) removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the printer left door assembly. See “Printer left door assembly removal” on page 4-75.
4. Remove the registration roll assembly. See “Registration roll assembly removal” on page 4-79.
5. Release the hooks securing the sensor (registration) (A) to the registration roll assembly (B).
6. Remove the sensor (registration) (A).
7. Disconnect the connector from the sensor (registration).
To Next Page
Loading...
