2-120 MFP Service Manual
7500-432, -632, and -832
295.02 Invalid combine size jam
Step Check Yes No
1 Check the document size.
Is the correct size document being inserted into the ADF?
Go to step 2. Insert the proper
size document into
the ADF.
2 Check the document tray media guide position.
Are the document tray media guides set correctly?
Go to step 3. Adjust the
document tray
media guides to
the proper position.
3 Check the connection of each ADF controller card assembly
connector.
Is each connector of ADF controller card assembly
connected properly?
Go to step 4. Connect each
connector of ADF
controller card
assembly properly.
4 Check the sensor (ADF width APS 1) for operation.
Perform the sensor (ADF width APS 1) test.
Open the ADF left cover assembly.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 1.
Operate the actuator of the sensor (ADF width APS 1).
Does the display on the operator panel change every time
the sensing area of the above sensor is blocked?
Go to step 6. Go to step 5.
5 Check the sensor (ADF width APS 1) for connection.
Is the above sensor connected properly?
Replace the
sensor (ADF
width APS 1).
Go to “Sensor
(ADF width
APS 1)” on
page 4-192.
Replace the
connection.
6 Check the sensor (ADF width APS 2) for operation.
Perform the sensor (ADF width APS 2) test.
Open the ADF left cover assembly.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 2.
Operate the actuator of the sensor (ADF width APS 2).
Does the display on the operator panel change every time
the sensing area of the above sensor is blocked?
Go to step 8. Go to step 7.
7 Check the sensor (ADF width APS 2) for connection.
Is the above sensor connected properly?
Replace the
sensor (ADF
width APS 2).
Go to “Sensor
(ADF width
APS 2)” on
page 4-193.
Replace the
connection.
To Next Page
Loading...
