Lexmark X862de - Tray 2 Media Size Mismatch in Length

Diagnostic information 2-195
7500-432, -632, and -832
Go Back
Previous
Next
Tray 2 media size mismatch in length
13 Perform a print test.
Does the error continue?
Replace the
printer engine card
assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-119.
Problem solved.
Step Check Yes No
1 Check the media.
Pull out the tray 2, and visually check it.
Is the media loaded in tray 2 properly?
Go to step 2. Load media
properly.
2 Check the media.
Pull out the tray 2, and visually check it.
Are the front media tray guide assembly, rear media tray
guide, and media tray end guide of tray 2 set correctly?
Go to step 3. Set the guides
properly.
3 Check the switch (media size) for tray 2 installation.
Is the switch (media size) for tray 2 installed correctly?
Pull out the tray 2, and visually check it.
Go to step 4. Install the switch
(media size) for
tray 2 correctly.
Go to “Switch
(media size)
removal” on
page 4-19.
4 Check the switch (media size) for tray 2 connection.
Is the switch (media size) for tray 2 properly connected?
Replace the switch
(media size).
Go to “Switch
(media size)
removal” on
page 4-19.
Replace the
connection.
5 Check the roll for tray 2.
Pull out the tray 2, and check it.
Is the feed roll, separation roll, and pick roll free of excess
wear and contamination?
Go to step 6. Clean or replace
the feed roll,
separation roll,
and pick roll.
Go to “Feed roll
removal” on
page 4-45,
“Separation roll
removal” on
page 4-49, and
“Pick roll
removal” on
page 4-51.
6 Open the printer left door assembly, and visually check it.
Check the media position.
Does the media touch the sensor (registration)?
Remove the
media.
Go to step 7.
Step Check Yes No