3-16 MFP Service Manual
7500-432, -632, and -832
After selecting one of the available sensors, you can manually toggle the sensor between its two values (Open
or Closed). Open appears on the display when the sensor is open, and Closed when the sensor is closed.
Press Stop to exit the test.
BASE SENSOR TEST
This test verifies that the sensors in the base machine are operating properly.
To run the Base Sensor Test:
Touch BASE SENSOR TEST from the Diagnostics Menu. The panel displays BASE SENSOR TEST in the
header row and the following categories of sensors below the header row:
• Cover and Door
• Devices
• Exit Level
• Media Path
After you select a category of sensors, the panel displays the name of the selected category in the header row
and each sensor in that category. You must select a specific sensor from this list to view and toggle the sensor’s
state. After you select a specific sensor, [Sensor Name] Testing... appears on the display and displays the
sensor’s name in the header row and the sensor’s name and current state appears below the header row.
Cover and Door Sensors
Device Present Functions
Exit Level Sensors
Sensor Name Description
Door A printer left Switch (printer left door interlock)
Door B printer left/lower Switch (left lower door interlock)
Door C 2TM/TTM left Switch (2TM/TTM left door interlock)
Door D duplex left Switch (duplex left door interlock)
Door E exit 2 left Switch (exit 2 left door interlock)
Door J front Switch (printer front door interlock)
Door K HCF top Switch (HCF top door interlock)
Sensor Name Description
PC unit present Indicates the PC cartridge is installed
Exit2 present Indicates the exit 2 unit assembly is installed
Sensor Name Description
Std bin full exit 1 Sensor (std bin full exit 1)
Std bin full exit 2 Sensor (std bin full exit 2)
To Next Page
Loading...
