Lexmark X862de - Size Mismatch Jam (MIX-Size)

Diagnostic information 2-117
7500-432, -632, and -832
Go Back
Previous
Next
295.00 Size mismatch jam (mix-size)
11 Check the inverter solenoid assembly for connection.
Is the above motor connected properly?
Replace the
inverter solenoid
assembly.
Go to “Inverter
solenoid
assembly
removal” on
page 4-181.
Replace the
connection.
12 Check the registration motor (forward or reverse) test.
Perform the registration motor test.
Open the ADF left cover assembly.
Remove the ADF rear cover. Go to “ADF rear cover
removal” on page 4-173.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Scanner Motor Tests.
4. Touch ADF registration drv mtr.
5. Touch Forward or reverse.
Does the ADF registration motor operate properly?
Go to step 14. Go to step 13.
13 Check the ADF registration motor for connection.
Is the above motor connected properly?
Replace the ADF
registration
motor.
Go to “ADF
registration
motor removal”
on page 4-209.
Replace the
connection.
14 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the ADF
controller card
assembly.
Go to “ADF
controller card
assembly
removal” on
page 4-175.
Go to step 15.
15 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-130.
Problem solved.
Step Check Yes No
1 Check the document tray media guide position.
Are the document tray media guides set correctly?
Go to step 2. Adjust the
document tray
media guides to
the proper
position.
Step Check Yes No