4-234 MFP Service Manual
7500-432, -632, and -832
2000-sheet dual input (TTM)—tray 3 mylar actuator removal
1. Remove the tray 3 assembly. See “2000-sheet dual input (TTM)—tray 3 assembly removal” on
page 4-224.
2. Remove the tray 3 front cover. See “2000-sheet dual input (TTM)—tray 3 front cover removal” on
page 4-225.
3. Remove the tray 3 rear cable assembly. See “2000-sheet dual input (TTM)—tray 3 rear cable assembly
removal” on page 4-226.
4. Remove the tray 3 front cable assembly. See “2000-sheet dual input (TTM)—tray 3 front cable
assembly removal” on page 4-229.
5. Remove the media guide rack and pinion. See “2000-sheet dual input (TTM)—media guide rack and
pinion removal” on page 4-230.
6. Move both media guides fully inward.
7. Lift the front edge of the bottom plate (A) from the tray.
8. Remove the bottom plate (A) from the tray.
9. Remove the two screws securing the bracket (B) to the tray.
10. Remove the rear media guide (C).
11. Remove the mylar actuator (D) by sliding it out of the tray in the direction of the arrow.
Note: Before re-installing, ensure the bosses on the rear media guide (C) are fitted into the slots on the mylar
actuator (D) as shown in the figure.
To Next Page
Loading...
