Lexmark X862de - Registration Roll Assembly Removal

Repair information 4-79
7500-432, -632, and -832
Go Back
Previous
Next
Registration roll assembly removal
1. Remove the MPF rear cover. See “MPF rear cover removal” on page 4-58.
2. Remove the MPF feed unit assembly. See “MPF feed unit assembly removal” on page 4-54.
3. Remove the printer left door assembly. See “Printer left door assembly removal” on page 4-75.
4. Remove the bosses on both ends of the vertical turn mylar guide (A).
5. Remove the vertical turn mylar guide (A).
Warning: The vertical turn mylar guide (A) requires moderate force to remove. Be careful not to
damage it.
6. Remove the two screws securing the registration mylar guide assembly (B) to the registration roll
assembly (C).
7. Remove the registration mylar guide assembly (B).
8. Remove the two screws securing registration roll assembly (C).
9. Remove the registration roll assembly (C) by lifting it upward and outward in the direction of the arrow.
Note: When removing the registration roll assembly (C), use care not to damage the two harnesses
located on the backside of the assembly.
10. Release the harness from the clamp.
11. Disconnect the two connectors from the registration roll assembly (C).
Note:
• Before reinstalling the registration roll assembly (C), fit the bosses on the rear center of the assembly
into the holes.
• Before reinstalling the two harness connectors, ensure they are plugged in properly.
B
C
Boss
A
Boss
Front
Clamp
Connector
Connector
C
Left view