2-180 MFP Service Manual
7500-432, -632, and -832
No media in the select media tray
4 Perform a print test.
Does the error continue?
Replace the
printer engine card
assembly.
Go to “Printer
engine card
assembly
removal” on
page 4-119.
Problem solved.
Step Check Yes No
1 Check the media.
Is the media loaded in the selected tray?
Go to step 2. Load media
properly.
2 Check the sensor (media out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 3.
5. Touch Media out.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 4.
5. Touch Media out.
Remove the appropriate media tray assembly.
Does the display on the operator panel change every
time the sensing area on the above sensor is blocked by
the media out actuator.
Go to step 4. Go to step 3.
3 Check the sensor (media out) for proper connection.
Check tray 3 and tray 4.
Is the above sensor connected properly?
Replace the
appropriate sensor
(media out).
Go to “2000-sheet
dual input (TTM)—
sensor (media out)
removal” on
page 4-262.
Replace the
connection.
4 Check the 2TM/TTM controller card assembly and the
printer engine card assembly for proper connection.
Are connectors P541 and P413 on the above cards
connected properly?
Go to step 5. Replace the
connection.
5 Perform a print test.
Does the error still occur?
Replace the 2TM/
TTM controller card
assembly.
Go to “2000-sheet
dual input (TTM)—
2TM/TTM controller
card assembly
removal” on
page 4-281.
Go to step 6.
Problem solved.
Step Check Yes No
To Next Page
Loading...
